QNAP TS-328 User Manual

d. Place the NAS in its normal upright position.
7. Power on the NAS.
Installing 2.5-inch Hard Drives or Solid State Drives
The TS-328 comes with 1 drive tray base that supports 2.5-inch hard drives or solid state drives. This tray
base is pre-installed in drive bay 3. For details, see Front Drive Numbering.
You can assemble additional 2.5-inch hard drive or solid state drive trays using the available drive tray
caddies and additional drive tray bases. For details, see Attaching the 2.5-inch Hard Drive or Solid State
Drive Tray Base.
You can purchase drive tray bases from QNAP or an authorized reseller. For details, go to https://
shop.qnap.com/.
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the NAS.
2. Remove the NAS cover.
a. Lay the NAS on its left side.
b. Remove the screws from the back of the NAS.
TS-328 User Guide
Installation and Configuration 13

QNAP TS-328 Specifications

General

Brand	QNAP
Model	TS-328
Category	Storage
Language	English