EasyManuals Logo

QNAP TS-453E User Manual

QNAP TS-453E
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
To avoid potential injury or damage to components, ensure that the drives and other internal system
components have cooled before touching them.
Observe electrostatic discharge (ESD) procedures to avoid potential injury or damage to components.
Power
To reduce the risk of re or electric shock, ensure that you only connect the power cord to a properly
grounded electrical outlet.
To avoid serious injuries, a trained service technician must disconnect all PSU cords from the device
before installing or replacing system components.
System Battery
To avoid potential battery explosion, causing injury or damage to components, ensure that you replace
the existing battery with a battery of the same type.
Dispose of used batteries properly according to local regulations or the instructions of the battery
manufacturer.
Moving Parts
Moving fan blades: Keep your body parts away from moving fan blades while the device is connected
to a power source.
Moving components: Keep your body parts away from other moving components.
The device is not suitable for use in locations where children are likely to be present.
Installation Requirements
Category Item
Environment Room temperature: 0˚C to 40˚C (32˚F to 104˚F)
Non-condensing relative humidity: 5% to 95%
Wet-bulb temperature: 27˚C (80.6˚F)
Flat, anti-static surface without exposure to direct sunlight, liquids,
or chemicals
Free from objects that may obstruct device ventilation or apply
pressure to the device or power cord
Hardware and peripherals Storage drives
For the list of compatible drive models, go to https://
www.qnap.com/compatibility.
Network cable
TS-x53E User Guide
Product Overview 11

Other manuals for QNAP TS-453E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QNAP TS-453E and is the answer not in the manual?

QNAP TS-453E Specifications

General IconGeneral
GPUIntel UHD Graphics
Flash Memory4 GB (Dual boot OS protection)
Drive Bays4 x 3.5-inch SATA 6Gb/s, 3Gb/s
Hot-swappableYes
M.2 SSD Slot2 x M.2 2280 PCIe Gen3 x1
SSD Cache Acceleration SupportYes
Network Interface2 x 2.5GbE RJ45
Form FactorTower
LED IndicatorsStatus, LAN, USB, HDD 1-4
Kensington Security SlotYes
Operating SystemQTS 5.0
ProcessorIntel Celeron J6412
CPU Architecture64-bit x86
Memory8 GB DDR4 (4 GB x 2)
Memory Slot2 x SO-DIMM
Drive Compatibility3.5-inch SATA hard disk drives, 2.5-inch SATA solid state drives
Maximum Internal Raw Capacity64 TB (16 TB drive x 4)
ButtonsPower, Reset
Power Supply Unit100-240V
Fan1 x 120mm
Operating Temperature0°C to 40°C (32°F to 104°F)
Operating Humidity5% to 95% RH

Related product manuals