Note
You may need to use a tool such as a slotted screwdriver to help push down and
release the latches.
e. Remove the top end of the front panel from the chassis.
f. Pull the front panel away at an angle.
Note
There are hooks at the bottom of the front panel that latch onto the chassis.
16. Remove the LED circuit boards from the front panel.
a. Remove the screws that secure the LED circuit boards to the front panel.
Note
• The pan head M3x5 screws require a Phillips #2 screwdriver.
• A torque of 5 kgf.cm (4.34 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
| NAS Repair Manual
Category D NAS Models 110
To Next Page
Loading...
Need help?
General
