QNAP TS-AI642 - Page 119

b. Attach the screws.
Note
• The pan head M2.5x3 screws require a Phillips #1 screwdriver
• A torque of 3 kgf.cm (2.60 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
3. Attach the system board to the system board tray.
a. Align the mounting holes in the system board with the screw holes on the tray.
b. Attach the screws.
| NAS Repair Manual
Category D NAS Models 118