c. Attach the screws that secure the front top cover to the chassis.
Note
• The at head M3x4 screws require a Phillips #2 screwdriver.
• A torque of 5 kgf.cm (4.34 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
12. Attach the rear top cover.
a. Place the rear top cover on the device.
b. Slide the rear top cover forward.
| NAS Repair Manual
Category E NAS Models 168
To Next Page
Loading...
