c. Tighten the screws that secure the rear top cover to the chassis.
13. Optional: Install handles.
a. Align the holes on the handle with the holes on the chassis.
b. Attach the screws that secure the handle to the chassis.
Note
• The at head M3x5 screws require a Phillips #2 screwdriver.
• A torque of 7 kgf.cm (6.08 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
| NAS Repair Manual
Category E NAS Models 169
To Next Page
Loading...
