QNAP TS-h1886XU-RP-R2 - Page 34

For details, see Replacing Expansion Cards.
3. Connect the expansion units to the NAS using the following topology.
Note
This image shows connecting the NAS to a TL-R400S and TL-R1200S-RP.
4. Power on the SATA JBOD expansion units.
5. Power on the NAS.
6. Verify that the expansion units are recognized by the NAS.
a. Log on to QuTS hero as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Connecting USB Expansion Units
To connect the device to USB expansion units, USB Type-A to USB Type-C cables or USB Type-C to USB Type-C
cables are required.
For required accessories details, see Expansion Unit Installation.
1. Connect the expansion unit to the NAS.
a. Connect the USB cable to the USB Type-B or USB Type-C port on the expansion unit.
b. Connect the USB cable to a USB 3.2 Gen 1 Type-A port on the NAS.
TS-h1886XU-RP User Guide
Installation and Conguration 33