QNAP TS-h1886XU-RP-R2 - Page 37

Installation methods Steps
Manual installation a. Click Manual Installation.
The Install Firmware window appears.
b. Click Browse.
The upload le window appears.
c. Select le.
d. Click Open.
Starts rmware installation.
Skip a. Click Skip.
Skips rmware installation.
7. Specify the following information
• NAS name: Specify a name with 1 to 14 characters. The name supports letters (A to Z, a to z),
numbers (0 to 9), and hyphens (-), but cannot end with a hyphen.
• Password: Specify an administrator password with 1 to 64 characters. The password supports all
ASCII characters.
8. Click Next.
9. Specify the time zone, date, and time.
Tip
QNAP recommends connecting to an NTP server to ensure that the NAS follows the
Coordinated Universal Time (UTC) standard.
10. Click Next.
The Congure the network settings screen appears.
11. Select Obtain an IP address automatically (DHCP).
12. Click Next.
The Cross-platform le transfer service screen appears.
13. Select the types of devices that you will use to access shared folders on the NAS.
14. Click Next.
15. Review the settings.
16. Click Apply.
A conrmation message appears.
Warning
Clicking Yes deletes all data on the drive before installing QuTS hero.
17. Click Yes.
• The QuTS hero installation progress bar appears.
• QuTS hero is installed.
Note
It may take a couple of minutes to complete QuTS hero installation.
TS-h1886XU-RP User Guide
Installation and Conguration 36