• Dispose of used batteries properly according to local regulations or the instructions of the battery
manufacturer.
Installation Requirements
Category Item
Environment • Room temperature: -40˚C to 70˚C (-40˚F to 158˚F)
• Non-condensing relative humidity: 5% to 95%
• Wet-bulb temperature: 27˚C (80.6˚F)
• Flat, anti-static surface without exposure to direct sunlight, liquids,
or chemicals
Hardware and peripherals • Computer or NAS
• Storage drives
For the list of compatible drive models, go to https://
www.qnap.com/compatibility.
• Network cable
Tools • Phillips #1 or #2 screwdriver
• Flat head screwdriver
• Anti-static wrist strap
Setting Up the NAS
Important
Read all safety requirements and information carefully before setting up the NAS or installing
NAS components.
1. Place your NAS device in an environment that meets the requirements.
For details, see Installation Requirements.
2. Install drives.
For details, see Installing 2.5-inch Solid-state Drives on 2.5-inch Trays.
3. Optional: Connect expansion units.
For details, see Connecting USB Expansion Units.
4. Connect the power cord and all applicable cables.
Note
The optional VCC GND 9-36V input requires a Euroblock connector.
TS-i410X User Guide
Product Overview 9
To Next Page
Loading...
