202 Chapter 12 Using Special Sync Output
3. Set the frame pulse pixel width (in the range from 1 pixel to
HTOT
- 1) by entering the
following command:
FSPW 100
4. Set the frame pulse delay (in the range from 0 <=
FSPD
< (
VTOT
-
FSPW
- 1) [default =
0]) by entering the following command:
FSPD 10
5. Save these settings by entering the following command:
ALLU
To configure line sync on the special sync output:
1. Enable the line sync signal by entering the following commands:
FSPG 0
PSPG 0
LSPG 1
ALLU
The value of composite sync
CSPG
does not matter once these are set.
2. Set the line sync pulse polarity by entering the following command:
LSPP 1 // 1 = high (default)
ALLU
To configure composite sync on the special sync output:
1. Enable digital composite sync by entering the following command:
SSST 2 (or 6,11)
Alternatively, you can press the DCS key on the front panel.
2. Enable the composite sync signal by entering the following commands:
FSPG 0
PSPG 0
LSPG 0
CSPG 1
ALLU
3. Set the composite sync pulse polarity by entering the following commands:
CSPP 1 // 1 = high (default)
ALLU
To Next Page
Loading...
