366 Appendix A Command Reference
HDMI
High-Definition Multimedia Interface protocol
Class Digital video signal control
Description Sets the current digital protocol. Restarting the generator does not change this setting.
The HDMI? query returns the current mode.
Command syntax HDMI mode
mode
0 to disable HDMI (use alternative protocol such as DVI 1.0)
1 to enable HDMI (default)
This command affects the DVPT parameter as shown below:
Query syntax HDMI?
Query response 0 or 1
Example
HDMI 0
ALLU
Interface hardware used HDMI setting DVPT setting
DVI only 0 0
12
HDMI 0 1
10
To Next Page
Loading...
