588 Appendix A Command Reference
XGIF
Generic InfoFrame Data
Class InfoFrame Generator (IFG) parameter
Description Writes generic InfoFrame packet data. This allows you to emulate any InfoFrame type
(including vendor-specific).
Note: The HDMI specification (section 5.2.3.2) requires that an HDMI packet must be
transmitted at least every two VSYNC periods, or the receiver will drop out of HDMI mode.
A Generic InfoFrame packet can be used for this purpose by enabling its repeat bit (see the
IFTR command).
Command syntax XGIF type version length data
type
0 to 255
version
0 to 255
length (bytes)
0 to 25 (bytes)
data (ASCII)
hexidecimal payload data in the form of ASCII characters—each representing one
4-bit nibble of data (if less than 50 ASCII characters, which is less than 30 bytes of
data, are specified, then the remaining bytes are set to zero)
Example The following example writes 10 bytes of generic InfoFrame data. The remaining bytes
11-25 will be set to zero.
XGIF 6 1 20 1122EE4455BB77FF99AA
Related commands IFTR, IFTG, IFGU
To Next Page
Loading...
