802BT/802R Video Test Generator User Guide 79
Note: The card you need is a Type 1, Battery Backed RAM PCMCIA card with at least
2 MB of storage. These cards are available from synchrotech P/N PCM-SRW-AM002
2MB. Flash or compact type memory cards will not work.
2. Use one of the following procedures to configure the generator to use a format with the
same pixel depth as the image:
• Select a built-in format with the appropriate pixel depth.
• Create a format with the appropriate pixel depth.
• Establish a terminal session with the generator and enter the following commands
to set the pixel depth to 32-bit (24-bit TrueColor) or 8-bit:
PELD 32; ALLU
or
PELD 8; ALLU
• Hold down the R key while pressing and releasing the G key to toggle the pixel
depth between 8 and 32-bit pixel depths.
3. Using the Image knob, select the CardBMP image, or enter this command:
IMGL CardBMP; ALLU
The image appears on the display.
4. To view an image from a different card, switch the cards, and then re-select the
CardBMP image.
To Next Page
Loading...
