Quantum Scalar i6000 Planning Guide

Chapter 3: System Specifications
Physical Specifications – Pallet
Scalar i6000 Planning Guide 57
Physical Specifications – Pallet
Pallet Specifications The library control modules, expansion modules, and parking modules
are each shipped on the same type of specially designed pallet. For dual-
robot new installs or upgrades, the robots will be shipped inside the
module.
The pallet’s dimensions are listed in Tab le 7.
Table 7 Pallet Dimensions –
Module Only
Physical Specifications – Library
This section contains the physical specifications for all possible library
configurations.
The maximum weight, distributed load, and point load figures provided
in the sections below were calculated using the heaviest configurations
for a given frame count. Where differences between Gen 1/Gen 2 or
single robotics/dual robotics exist, the heaviest number was used.
Note: If the library is installed on a raised floor, the raised floor should
be stabilized to prevent any horizontal movement. The library
has four point loads each on the control and expansion
modules.
This section covers:
• Configuration Rules on page 58
Height Width Length
87 in.
221.0 cm
42.5 in.
108.0 cm
48 in.
121.9 cm

Quantum Scalar i6000 Specifications

General

Form Factor	Rack-mountable
Interface	Fibre Channel, SAS
Product Type	Tape Library
Cooling	Redundant cooling fans
Dimensions	Varies by configuration
Weight	Varies by configuration
Operating Humidity	20% to 80% non-condensing
Scalability	Scalable
Drive Types	LTO
Redundancy	Redundant power supplies
Management	Web-based management
Tape Technology	LTO
Supported Media	LTO Ultrium 9, LTO Ultrium 8, LTO Ultrium 7, LTO Ultrium 6
Power Supply	Redundant power supplies
Non-operating Humidity	5% to 95% non-condensing