GV300 Manage Tool
TRACGV300MT001 - 26 -
3.2. Device Configuration in Professional Setting Mode
The manage tool is developed based on the @Track Air Interface Protocol. Please refer to “GV300
@Track Air Interface Protocol” for detail.
Following is a general procedure to configure GV300 with manage tool.
Step_1: Select “Bearer Setting Information”, after that the parameters of GTBSI show in
Command Operation Space.
Step_2: The command message which shall be sent to GV300 will be generated based on input
and displayed here. Please note this command message can also be sent to GV300
through SMS or GPRS.
Step_3: It is recommended to read the parameters from GV300 and edit based on them.
Step_4: Set APN parameters. Please refer to “GV300 @Track Air Interface Protocol” for the
meaning of each parameter.
Step_5: Click the “Send” button; download the parameters of GTBSI to GV300.
Note:
1. The parameters of GTSRI and GTBSI will be changed when change the parameters of
GTQSS.
Step_
Step_5
Step_3
Step_2
Step_4
To Next Page
Loading...
