GV300 Manage Tool
TRACGV300MT001 - 9 -
2. GV300 Manage Tool Interface
GV300 manage tool is PC software which can be used to configure GV300 through UART. It is
easy for the backend server developers to configure GV300 with manage tool, which has friendly
user interface. The correct command messages sent to GV300 will be displayed on the manage
tool. (These messages can also be sent by SMS or GPRS ).
The administrators can also use the manage tool to configure GV300 before selling. But it is
strongly recommended to establish a backend server and implement the way to control GV300 by
SMS or GPRS. Please refer to “GV300 @Track Air Interface Protocol” for detail.
Before using the manage tools please install driver for the USB data cable (DATA CABLE_M).
After that a new COM port can be found in the PC system, and then please follow the steps as
below:
1. Connect GV300 to 12VDC power supply and GV300 will power on.
2. Connect GV300 to PC with USB data cable (DATA CABLE_M).
3. Run “GV300 Manage Tool Vx.xx.exe”.
2.1. System Requirements
In order for this manage tool to run on your computer, you must use it in below operating system:
♦ Windows XP SP2 and above (32 & 64 bit);
♦ Windows Server 2003 (32 & 64 bit);
♦ Windows Server 2008 (32 & 64 bit);
♦ Windows Vista (32 & 64 bit);
♦ Windows 7 (32 & 64 bit);
♦ Windows 8 (32 & 64 bit);
Supported System Environments:
♦ Microsoft .NET Framework 4.0 or higher
Microsoft .NET Framework 4.0 download
link:
http://www.microsoft.com/en-US/download/details.aspx?id=17718
To Next Page
Loading...
Need help?
General
