Queclink GV300 - Load;Send All Configuration

GV300 Manage Tool
TRACGV300MT001 - 28 -
3.4. Load/Send All Configuration
Step_1: Before send all configurations, please load the configuration file or set all parameters in
commands. To load configuration file, please select “Read All Configuration” ” Load
Configurations From File”. And then select the configuration file you needed.
Step_2: You can set the parameters in commands base on the configuration file, and then click
“Send All Configuration” in toolbar.
NOTE: Command GTQSS, GTDAT, GTRTO will not be sent when “Send All Configuration”.
Step_3: Manage Tool will send all commands to device.
Queclink
Confidential