Quectel EM06 Series - DPR Signal; Antenna Tuner Control Interface

LTE-A Module Series
EM06 Series Hardware Design
EM06_Series_Hardware_Design 40 / 69
Module
Host
WAKE_ON_WAN#
10K
VCC from the Host
Figure 24: Reference Design of WAKE_ON_WAN#
3.10.4. DPR Signal
The module provides a DPR (Dynamic Power Reduction) signal for body SAR (Specific Absorption Rate)
detection. The signal is sent by a host system proximity sensor to the module to provide an input trigger
which will reduce the output power in the radio transmission.
Table 17: Function of the DPR Signal
Please refer to document [2] for more details about AT+QCFG="sarcfg" command.
3.11. Antenna Tuner Control Interface*
ANTCTL [0:3] signals are used for antenna tuner control and should be routed to an appropriate antenna
control circuitry.
More details about the interface will be added in the future version(s) of the document.
DPR Level
Function
High/Floating
Max transmitting power will NOT back off
Low
Max transmitting power will back off by executing AT+QCFG="sarcfg" command
NOTE