Quectel Smart EVB G2 User Manual

Smart LTE Module Series
Smart EVB G2 User Guide
Smart_EVB_G2_User_Guide Confidential / Released 53 / 59
1. For the details of powering on Smart module with DC adapter only, please refer to Chapter 4.1.3.
2. Inserting USB into USB interface after power supply is provided can also power on the module.
Communication Via USB or UART Interface 5.2.
5.2.1. Communication via USB Interface
1. Power on the module according to the procedures mentioned in Chapter 5.1.
2. Connect Smart EVB G2 and the PC with USB Type-C cable through USB Type-C interface and then
run the driver disk on PC to install the USB driver. The USB port numbers can be viewed through the
PC’s Device Manager, shown as below.
Figure 49: USB COM Ports
3. Open CMD tool: START All Programs  Accessory  Command Prompt.
4. Use the “adb shell” command to make the module enter into ADB mode. Then customers can use
USB ADB interface for test.
NOTES
Quectel
Confidential

Quectel Smart EVB G2 Specifications

General

Brand	Quectel
Model	Smart EVB G2
Category	Motherboard
Language	English