UMTS/HSPA+ Standard Module Series
UC200T-GL Mini PCIe Hardware Design
UC200T-GL_Mini_PCIe_Hardware_Design 7 / 51
1 Introduction
This document defines UC200T-GL Mini PCIe module, and describes its air interfaces and hardware
interfaces which are connected with customers’ applications.
This document helps customers quickly understand module interface specifications, electrical
characteristics, mechanical specifications and other related information of the module. To facilitate
application designs, it also includes some reference designs for customers’ reference. The document,
coupled with application notes and user guides, makes it easy to design and set up wireless applications
with UC200T-GL Mini PCIe.
FCC Certification Requirements.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a
mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna
installation and operating configurations of this transmitter, including any applicable source-based time-
averaging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion Requirements
of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user’s body
and must not transmit simultaneously with any other antenna or transmitter.
3.A label with the following statements must be attached to the host end product: This device contains
FCC ID: XMR202007UC200TGL.
4.To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, maximum antenna gain (including cable loss) must not exceed:
To Next Page
Loading...
