Quicksilver 755PH — System & Component Overview and Operaon
24
To Operate the Macerator:
1. Make sure the macerator seacock is in the open posion.
2. Press and hold the macerator switch. The macerator switch is a momentary switch, which
means that it needs to be held in the “ON” posion during operaon.
3. When the tank is empty, release the macerator switch.
4. Return the macerator seacock back to the closed posion.
Dockside Pumpout
The dockside pumpout deck plate is located on the port deck trail, and is marked with the ISO
symbol WASTE. The dockside facility will have the proper connecons / ngs to pump the holding
tank out.
Maintenance
Maintenance of the waste system will require you to check the ngs and hoses to make sure that
there are no leaks. If the system does require maintenance, contact your local dealer. Quicksilver®
recommends that you pump out the system before long periods of non-use. If you are storing the
boat during the winter, we recommend you winterize the system.
To Winterize the Waste System:
1. Empty the holding tank either via the macerator in an approved locaon or the dockside
pumpout.
2. Pump water through the system (via the toilet) to remove any residue waste.
3. Empty the holding tank again, removing all liquids.
4. Pour an environmentally safe anfreeze (Propylene Glycol based) in the toilet and pump
throughout the system.
Refer to the toilet manufacturer’s requirements for addional winterizaon procedures.
4. Bilge Pumps
Your vessel is equipped with two bilge pumps, with one located in the a secon of the boat, and
the second one located in the forward secon of the boat. Access to the a bilge pump is via the
motorwell access plate, while access to the forward bilge pump is through the interior liner oor a
hatch. Both bilge pumps are rated for 500 GPH, and are acvated automacally by a built in mercury
free oat switch when the water in the bilge reaches a predetermined level. You can also manually
operate the bilge pump at the dash by pressing the bilge pump switch.
Inspect the bilge pump intakes and keep them free of dirt or material which may impede the ow of
The dockside pumpout deck plate does not have a chain
connecng the cap to the deck plate. Use cauon not to
drop the deck plate cap into the water.
Pumpout deck plate
Dockside Pumpout
To Next Page
Loading...
Need help?
General
