Quicksilver 755PH - Motorwell Prep Station (Optional)

Quicksilver 755PH — System & Component Overview and Operaon
44
25. Motorwell Prep Staon (oponal)
Located over the motorwell, an oponal prep staon is available that contains a cung board and
two rod holders. This prep staon covers the motorwell, however, it does not interfere with the
normal operaon and trimming of the engine. If you want to lt the engine to trailer posion, you
must rotate the prep staon forward. Simply li the prep staon from the rear and it will rotate out
of the way.
Table base
Table leg
Table
Table storage
Table leg storage
Cockpit Table
A Center Cockpit Hatch
Motorwell Prep Staon
Prep staon in lowered posion
Prep staon in raised posion
Before lng the engine to trailer mode, make sure that the
prep staon is rotated forward. Failure to do so could cause
damage to the engine and prep staon.
Cung board
Rod holder