Quicksilver 755PH User Manual

35
Quicksilver 755PH — System & Component Overview and Operaon
L6 Verado Hydraulic Steering
Steering wheel
Helm pump
Hydraulic uid lines
Power assist pump
Verado powered boat, uid is added at the power assist pump, located in the starboard forward corner
of the cockpit. To access, open the forward cockpit oor access hatch. Next, remove the cover on the
power assist pump and unscrew the cap.
REFER TO OWNER’S MANUAL PACKAGE FOR INSTRUCTIONS AND WARRANTY INFORMATION.
14. Engine Controls
Depending on the engine installed on your boat, you will either have a mechanical gear shi/throle
control unit or a “drive by wire” Digital Throle and Shi (DTS®) control unit. The control unit, located
to the starboard of the steering wheel, acvates both the shiing and throle for the engine.
To start the engine, the control unit must be in the NEUTRAL posion. When in neutral, the engine is
running, but the propeller is not spinning. There is a throle only buon that when pressed, will allow
you to operate the throle without the propeller spinning. On the mechanical shi controller, the
buon is located at the center of the throle control, and when moved back to the center posion, the
buon will automacally re-engage the shiing mechanism.
For the DTS control, the Throle Only buon is located on the control funcon pad. To engage, press
the “Throle-Only” buon on the keypad when the engine is in neutral. A light located above the
Throle-Only buon will turn on and the green neutral light will begin to ash. When you place the
ERC in gear, the warning horn will beep, however, the propeller is not turning. To disengage, return the
ERC lever back to neutral and press the “Throle-Only” buon. The light located above the Throle-
Only buon will turn o and the green neutral light stops ashing and remains illuminated.
Moving the control lever forward from neutral engages the forward gear and thrust. Moving the
control lever backwards from neutral engages the reverse gear and thrust. The throle lever controls
the RPM of the engine and the speed of the boat.
Power Trim & Tilt
The power trim, located on the side of the gear shi throle handle, allows you to raise and lower the
engine for trailering and launching the boat. It also allows you to adjust the engine to create the
opmum run angle for the boat to achieve best all around performance (fuel consumpon, speed).

Quicksilver 755PH Specifications

General

Brand	Quicksilver
Model	755PH
Category	Boats
Language	English