Quicksilver 755PH User Manual

Quicksilver 755PH— Electrical Systems
47
1. DC Electrical System
The DC electrical system is powered by two baeries, and are kept charged by the engine driven
alternator or by the baery charger when connected to AC power. The baery voltage is indicated by
the voltmeter screen located on the SmartCra
TM
tachometer.
2. Baeries
Refer to your engine owner’s manual for exact baeries requirements. All baeries in a baery bank
should be of the same type, age, and rang.
To remove the baery cables:
1. Turn o all items drawing power from the baery.
2. Turn the baery switches to the OFF posion.
3. Remove the negave cable rst, then the posive cable.
To replace the cables, install the posive cable rst, then the negave cable.
3. Baery Boxes
The baery boxes, located in the bilge, house the two baeries. These boxes can be accessed by
opening the forward center cockpit hatch. The baeries can be installed or removed by loosening the
strap and removing the lid on the baery box. They should always be installed and secured with the
baery boxes installed on your boat. This will ensure that the baeries will not move around while the
boat is underway.
4. Baery Selector Switch
Your vessel is equipped with a baery switch to control the delivery of DC power from the baeries.
The baery switch is located on the port a corner of the cockpit behind an access door.
There is a single baery switch that controls two isolated baery banks. When you turn the baery
switch to posion “1”, power is provided from the rst baery. When you turn the baery switch to
posion “2” power is provided from the second baery.
The baery switch also has the ability to combine baery banks at posion “1 & 2”. This is the
recommended posion for normal operaon as it will allow both baeries to be charged when the
engine is running.
The boat may be operated on one baery at a me when using accessories without the engine
running to reserve power in the opposite baery.
NOTE: Never operate or turn o the baery switch when the engine is running as it may cause
damage to electronic components on the boat. Always operate the switch with the engine and
accessories o.
Never use an open ame in the baery storage area. Avoid
striking sparks in the baery area.
Always disconnect the baery before doing any work on the
electrical system. Never turn o the baery switches or
disconnect the baery cables while the engines are running.

Quicksilver 755PH Specifications

General

Brand	Quicksilver
Model	755PH
Category	Boats
Language	English