Quicksilver 810 Arvor - Page 37

25
Quicksilver 810 Arvor — System & Component Overview and Operaon
connuously. Press the on/o switch again within 6 seconds . The system will conrm that it is ready
for use when the LED light remains green and the buzzer sounds twice.
To move the bow to the port direcon, push the joysck to the le. To move the bow to the starboard
direcon, push the joysck to the right. Refer to the thruster owner’s manual for complete details on
the operaon and warranty informaon.
To turn o the bow thruster controls, press the on/o switch once.
If 2 control panels are installed at separate helms, never
operate the bow thruster from both panels simultaneously.
Refer to the bow thruster owner’s manual for exact baery
requirements
Bow Thruster
Baery switch
Charge relay
Control panel
Do NOT test the bow thruster while the boat is out of the
water, unless you are certain that everyone is a safe
distance from the thrust tube.
Never allow the bow thruster to run for longer than 5
seconds with the boat is out of the water.
Bow Thruster Movement