© Copyright Qvis ®. All documentation rights reserved. 16
Picture 2.2.5-4 Time settings
System→ Maintenance
Enter system maintenance interface, See picture 2.2.6-5.
Click ‘Reboot’ to reboot the device. Click ‘Restore’ to restore device
parameters. It will easily restore the other parameters except IP
address, subnet mask, gateway, 8000 port number, DNSS address and
user name management information. Click ‘Default’ and it will
completely restore device parameters to default settings. Parameter
import (‘Import Config. File’) will allow you to install a particular
configuration file; parameter export will export current configuration file.
(Click ‘Export’ then it will be exported to PC after 59 seconds, then it will
automatically go to the Web login interface)
Click ‘Browse’, choose local upgrade file or upgrade catalogue, then
click ‘upgrade’ to upgrade device version. ‘Status’ shows the current
upgrade progress, after the upgrade is complete, you will be prompted
that upgrade was successful.
Note: The upgrading process will take around 1 to 10 minutes;
please do not disconnect power to the device during the process.
The device reboots automatically after the device has been
upgraded.
To Next Page
Loading...
Need help?
General
