The dome supports 8 auto cruise groups and each cruise
supports 32 presets. Please check the following steps to
set up cruise.
1. SEQ NO.: Move the cursor here and click IRIS + to
enter the Sequence Number setup. Click the up or
down button to select a preset number (1-8) and click
IRIS + to confirm.
2. TITLE: Move the cursor here and click IRIS + to
enter the Sequence Title setup. Check the details
above in DOME TITLE Settings.
3. <SEQUENCE SET>: Move the cursor here and click
IRIS + To enter. Move the cursor to EDIT and click
IRIS + enter Edit mode of sequence. Move the left
and right button to select each item.
a) When the < > is on the item NO., move the up or
down button to select the Serial NO. Of the
preset in a sequence. There are up to 32
presets in each sequence.
b) When the < > is on the item PRESET, move the
up or down button to select the preset NO. That
the user wants to add in the sequence.
c) When the < > is on the INTERVAL, move the up
or down button to select the interval time
between each preset.
d) When the < > is on the last item, move the up or
down button to select edition mode as “INS
(insert)”, “ok” and “delete”.
e) Click IRIS + when selecting INS to insert the
settings into the position of current Serial No.
f) Click IRIS + when selecting OK to override the
settings of Current Serial No.
g) Click IRIS + when selecting delete to delete the
settings of the Current Serial No.
h) Click IRIS + to save all the setting and click IRIS
CLOSE to exit.
1. DELETE/START: Move the cursor here and click
IRIS + to delete/start the current sequence.
To Next Page
Loading...
Need help?
General
