User can configure the IR LED working mode via
the ‘IR LED’ options within the ‘DOME SETTINGS’
menu. The configuration options are as follows:
1. CONTROL MODE:
2. SENSITIVITY:
Here the user can manually set the
sensitivity from 1-5. The smaller the number
is the lower the light level of the environment
will be when the IR LEDs are turned on.
3. NEAR/FAR POWER COMPENSATION:
When near power opens or far power opens
according to the power setting, you can set
the near/far power compensation to either:
10%, 20%, 30%, 40%, 50%,
4. AUTO CONTROL:
When the IR LEDs are on, they will turn its
power consumption to the standby status,
which will effectively extend the service life of
IR LEDs. And under this mode, when objects
appear in the screen, the IR LED will turn its
power consumption back to the normal
status.
To Next Page
Loading...
Need help?
General
