12 QD134-15
STOPP ING THE CAR
Use the ignition switch to turn off the car. Do not turn the car off via the master switch, unless in an
emergency. Keeping the master switch turned on after the engine has stopped running allows the cooling fan
and pump to continue to run if required to prevent heat soak. After 120 seconds they will automatically turn
off and the master can be switched off.
BRAK E BIAS
conditions. As a starting point, we recommend starting at 57%, which is 7% biased towards the front. During
wet conditions it is advisable to move the bias rearwards at around 7% (see wet setup guide).
IMPORTANT:
Remember the engine is not designed to run backwards, if you have a spin make sure you depress the
clutch. If the engine runs backwards without the clutch depressed it will damage the starter motor. Never
restart the car if you did not depress the clutch. If the starter spins backwards the starter motor
and starter clutch need to be inspected back at the pits to ensure there has been no damage.
To Next Page
Loading...
