43 QD134-15
9.12 REPACKING DRIVESHAFT GREASE
The driveshafts should be stripped, cleaned and re-greased every 10 hours of running. To do this, remove the
driveshafts from the car, then remove the CV boot clips and slide them back away from the housing. Remove
both housings and clean all the old grease in a wash tank. When re-assembling the driveshafts a set amount
of grease should be applied to each end of the driveshaft, the amount is listed below. New clips should be
fitted to the CV boots to prevent them from coming off.
SR1 Driveshaft Grease (Per Joint): 70g
Shaftec 70g Driveshaft Grease Part Number: TO0004
To Next Page
Loading...
