Note: If the same frequency already exists
on another channel, the scanner beeps and
displays that channel. Press CL to cancel, or
press ENT/PGM to store the frequency in
both channels.
Search Skip Memory
You can skip up to 50 unwanted frequencies
during a limit search, fine tune, service bank, or
Signal Stalker I search.
Note: You cannot skip frequencies during
WX service search.
To skip a frequency, press L/O when the scanner
stops on the frequency during a search. The
scanner stores the locked-out frequency in
memory and automatically resumes the search.
To clear a single frequency from skip memory:
1. Press PSE to stop the search.
2. Press T or S to select the frequency.
L/O
appears.
3. Press L/O.
L/O
disappears.
To clear all skipped frequencies at once:
1. While searching, press PSE.
2. Hold down L/O until the scanner beeps twice.
Notes:
• If you selected all frequencies to be skipped
within the search range, the scanner beeps
3 times and does not search.
• If you select more than 50 frequencies
to skip, each new frequency replaces a
frequency previously stored, beginning with
the first stored frequency.
• Press T or S to select a skipped frequency
during pause.
L/O
appears when you select
a skipped frequency.
To Next Page
Loading...
