22
Scanning
Manually Selecting a Channel
You can continuously monitor a single channel
without scanning. This is useful if you want to
monitor a specific channel or if you hear an
emergency broadcast on a channel and do not
want to miss any details, even though there might
be periods of silence.
To directly access a channel:
1. Press MAN to stop scanning.
2. Enter the bank and channel number and press
MAN. The selected channel appears.
To stop at a channel while scanning:
1. Press MAN to stop scanning.
2. Press T or S to select the next or previous
channel.
3. Press SCAN to resume scanning.
Weather Scan
To scan for weather transmissions:
1. Press WX/
.
WX
appears. Change the
search direction by using T or S.
2. To stop the search, press PSE.
PAUSE
appears.
Weather Alert
1. Press WX/ to start the weather scan.
2. Press PRI/ALERT.
ALT
appears.
If the scanner detects the 1050Hz weather alert
signal, it sounds an alarm for 5 minutes and
ALT
blinks. After the 5-minute alarm, the scanner
beeps every 10 seconds.
Press any key to turn off the alert. The audio turns
on so you can hear the weather broadcast.
To Next Page
Loading...
