20
Searching
• UHFbnd: UHF Band. Set to
On
to search
UHF Band (380-512MHz).
• IntrPt: Voice Interrupt. While Signal Stalker I
is on and the scanner is receiving an audio
signal (voice) in normal scanning, the
scanner checks the Signal Stalker I every 2
seconds causing the audio signal to break at
that moment.
Set Voice Interrupt to
On
if you want to
keep the Signal Stalker I active despite
interruptions while the scanner is receiving
an audio signal. Set to
Off
if you do not
want to hear interruptions. The scanner
resumes checking signals when the audio
signal ends.
To Next Page
Loading...
