Powering Your Scanner
You can power your scanner from a wall outlet, or from your vehicle’s
battery.
You must use a power source that supplies 12V DC and
delivers at least 600 mA. Its center tip must be set to positive
and its plug must t the scanner’s DC 13.8V jack. The supplied
AC adapter and DC power cord meet these specications.
Using a power source that does not meet these specications
could damage the scanner or the adapter.
Wall Outlet
1. Connect the tip of the supplied AC adapter to the DC 13.8V jack
at the rear of your scanner.
2. Plug the AC adapter into your wall outlet.
To prevent electric shock, do not use the AC adapter’s
polarized plug with an extension cord, receptacle, or outlet
unless you can fully insert the blades to prevent blade
exposure.
To avoid injury, do not connect the provided power adapter to
a ceiling outlet.
To Next Page
Loading...
Need help?
General
