Installing Your Scanner
You can mount your triple trunking scanner in your vehicle or use it as
a base station.
Setting Up a Mobile Base
You can place your scanner on a desk, shelf, or table to use it as a
base station. Because the speaker is on the bottom of the scanner,
you can use the mounting bracket to elevate your scanner off the
surface for better sound.
To you use the scanner on a at surface:
1. Attach the three protective rubber feet to the mounting bracket.
Do not use them if you are mounting the bracket with
screws.
2. Slide the scanner into the bracket,
aligning the scanner’s side holes
with the holes in the bracket,
and then screw the mounting
knobs into the scanner.
Bracket Mounting
You can mount your scanner under or on top of the dashboard a
desk, shelf, table or other at surface, using the mounting bracket.
1. Use the supplied mounting bracket as a template to mark
positions for the two mounting screws.
2. At the marked positions, drill holes slightly smaller than the
screws.
When drilling holes, avoid obstructions behind the mounting
surface.
To Next Page
Loading...
Need help?
General
