Locking Out Talk Group IDs
You can only lock out Talk Group IDs when the scanner is in the
Closed mode.
To lock out Talk Group IDs:
1. Press PROG then TRUNK.
2. Press FUNC, or to move to the desired bank.
3. Press or to select the ID.
4. Press L/OUT to lock out the ID. “lo” changes to “LO.”
5. To remove the lockout from a trunking ID, manually select the ID
memory, and press L/OUT. LO changes to lo.
You cannot clear all lockouts from a talk group at the same
time.
To review locked-out Talk Group IDs:
1. Press PROG then TRUNK.
2. Press FUNC. Then L/OUT. The rst locked out ID appears. If the
ID memory bank has no locked-out ID, you hear the low beep
tone.
3. Press or to scroll through the list.
4. Press PROG to exit.
Turning Off Sub-Banks
To turn off a sub-bank:
1. Press TRUNK repeatedly to select the desired sub-bank.
2. Press FUNC then 1 to turn the sub-bank on if it is off or off if it is
on.
To Next Page
Loading...
Need help?
General
