To remove your scanner from the
DIN sleeve, insert the two keys
straight into the scanner’s front
panel and pull the scanner out.
Connecting the Antenna
To connect an external antenna, always follow the installation
instructions supplied with the antenna. Use 50-ohm, RG-58, or RG-8,
coaxial cable. If the antenna is over 50 feet from the scanner, use RG-
8 low-loss dielectric coaxial cable. If necessary, RadioShack carries a
variety of adapters.
To attach the supplied antenna:
1. Align the antenna slots with the
tabs on the scanner, and slide
the antenna into place.
2. Turn and push down until the
antenna locks into place.
Warning: Use extreme caution when
installing or removing an outdoor antenna. If the antenna starts to
fall, let it go! It could contact overhead power lines. If the antenna
touches a power line, touching the antenna, mast, cable, or guy
wires can cause electrocution and death. Call the power company to
remove the antenna. DO NOT attempt to do so yourself.
To Next Page
Loading...
Need help?
General
