15
Follow these steps to install the transceiver as a base station.
1. Mount the base station antenna as described in its owner's
manual.
Warning:
Use extreme caution when you install or remove
a base station antenna. If the antenna starts to fall, let it go!
It could contact overheard power lines. If the antenna
touches a power line, contact with the antenna, mast, cable,
or guy wires can cause electrocution and death. Call the
power company to remove the antenna. DO NOT attempt to
do so yourself.
2. Connect the antenna to the
ANT
jack on the back of the
transceiver.
3. Connect the transceiver's black power wire to the negative
(–) terminal on the DC power supply.
4. Connect the transceiver's red wire (with in-line fuse holders)
to the positive (+) terminal on the DC power supply.
5. Connect the single–connector end of the power cord to the
connector on the back of the transceiver.
6. Connect the DC power supply to a standard AC outlet.
19-1110.fm Page 15 Friday, March 24, 2000 9:42 AM
To Next Page
Loading...
Need help?
General
