37
REPLACING THE FUSE
Your HTX-212 (and vehicle) are protected by a 15-amp fuse in the HTX-
212’s positive (red) power wire. If the HTX-212 does not turn on, even
when you are sure the power wire is properly connected to a 12V DC
power source, check the fuse and replace it, if necessary.
1. Snap open the in-line fuse holder.
2. Remove the fuse from the holder, and slide the fuse out of the end
connectors.
3. If the fuse’s filament is no longer intact, replace the fuse with a 15-
amp 1
1
/4 ¥
1
/4-inch fuse (Cat. No. 270-1073).
4. Replace the fuse in the holder and snap it closed.
Caution: Use only a fuse of the recommended size and type. Using
another type fuse, or defeating the fuse protection, could damage your
vehicle or your HTX-212. If the fuse frequently blows, there is a problem
with the HTX-212 or its wiring. Have that problem fixed as soon as possi-
ble.
19-1125.fm Page 37 Tuesday, August 3, 1999 9:47 AM
To Next Page
Loading...
Need help?
General
