7
MOUNTING THE HTX-212 IN A VEHICLE
When you select a mounting location for the HTX-212, be sure:
• You can easily reach it
• No wires or cables will interfere with the vehicle’s operation
• It is not directly in front of heating vents
• All wires will reach their connection points
Use the supplied screws, metal washers, bracket, rubber washers, and
mounting knobs, as shown, to mount the transceiver.
Cautions:
• Install the transceiver only in a vehicle that has a 12-volt, nega-
tive-ground electrical system.
• To avoid damaging your vehicle’s electronic systems, contact
your vehicle’s manufacturer before you install the HTX-212 to find
out about the proper transceiver mounting locations, antenna
locations, and power and antenna cable routing guidelines.
• Do not apply power to the transceiver until after you properly
mount and connect an antenna.
19-1125.fm Page 7 Tuesday, August 3, 1999 9:47 AM
To Next Page
Loading...
