11
Scanner Setup
BANK 1 PGM
DLY
Example shows entering bank 1 channel 00.
Note: If you entered an invalid bank or channel number, Error
appears and the scanner beeps. Enter a valid bank or channel.
5. Use the number keys to enter the frequency, pressing
•
/CLR/DELAY for
the decimal point.
6. Press ENT/PROGRAM to store the frequency into the channel.
7. To program the next channel in sequence, press S or T and repeat
Steps 5 and 6.
Notes:
• If you entered an invalid frequency in Step 5, Error appears and the
scanner beeps. Enter a valid frequency.
• If you entered a frequency in Step 5 that already exists on another
channel, the scanner beeps and displays that channel. Press
•
/CLR/
DELAY to clear the display, or press ENT/PROGRAM to store the
frequency in both channels.
• The scanner automatically rounds the entered number to the nearest
valid frequency. For example, if you enter 151.473 (MHz), your scanner
accepts it as 151.475.
• After a transmission, the scanner automatically pauses for 2 seconds on
the channel before proceeding to the next active transmission. Press
•/CLR/DELAY to turn the delay function on or off. The scanner stores
this setting in the channel.
If you do not have a list of frequencies in your area, you can use a fine tune
or service search to find transmissions. You can also use an online resource
such as www.radioreference.com.
To Next Page
Loading...
