18
Scanning
PGM
WX
3. Press T or S to select F0 to F14. If a FIPS code is not programmed,
------- appears.
4. Use the keypad to enter the FIPS code.
5. Press ENT/PROGRAM to store the FIPS code or press •/CLR/DELAY to
clear inputted FIPS code.
PGM
WX
6. To set the scanner so it alerts you when you receive any FIPS code, press
T or S to select All FIPS, then press ENT/PROGRAM. The scanner
returns to Weather Scan Pause Mode.
7. To set the alert only for one of the areas you have programmed, press
T or S to select F0 to F14, then press ENT/PROGRAM. The scanner
returns to Weather Scan Pause Mode.
To clear a FIPS code:
1. In FIPS Programming Mode, press T or S to select F0 to F14.
2. Press 0 and then press ENT/PROGRAM. ------ appears.
PGM
WX
Skywarn
The Skywarn function lets you jump directly to the last channel in memory
(Bank 9, Channel 19) from any mode by pressing and holding WX/
. The
scanner goes into manual mode and starts receiving transmissions in the last
channel.
To Next Page
Loading...
