22
Advanced Programming
Advanced Programming
You can clone your scanner by transferring the programmed data to or from
another PRO-136 scanner using a connecting cable. You can also upload or
download programmed data from a PC through wired programming.
Cloning Your Scanner
You can clone all the frequencies in
your PRO-136 to another PRO-136 or
PRO-135 using an optional interface
cable with 1/8-inch phone plugs on
both ends.
1. Make sure the scanners are turned
off and then plug the cable into
each scanner’s PC/IF jack.
2. Turn on both scanners. WirEd and PGM appear.
PGM
3. Press T or S on the scanner from which you want to send frequencies.
This is the “master unit.” The receiving scanner is the “slave unit.”
4. Press ENT/PROGRAM on the master unit to send the data. SEnd and the
transfer progress are displayed in the master unit.
BANK0 1 2 3 PGM
PC/IF Jack
To Next Page
Loading...
