Radio Shack PRO-2055 - Storing Known Frequencies into Channels

30
The Basics
weak to understand. Most users prefer to position
the squelch control a little bit past the point of
threshold to avoid receiving noise or signals that
are too weak to understand.
storing known frequencies into
channels
Good references for active frequencies are
RadioShack’s Police Call, Aeronautical Frequency
Directory, and Maritime Frequency Directory. We
update these directories every year, so be sure to get a
current copy.
Follow these steps to store frequencies into channels.
If you are storing frequencies for an EDACS
system, you must store them in order, with the
fi rst frequency in channel 1 for the current bank.
For example, if you want to store frequency of
150.0000, 150.0125, 150.0250, and 150.0375 MHz,
you must store them in Channels 1, 2, 3, and 4
respectively.
When M appears on the display, you can use FUNC
and the arrow keys to select your desired bank and
channel number.
1. Press MAN, enter the bank (0-9) and channel number
(00-99) where you want to store a frequency, then
press MAN again. M and the bank and channel
number appear at the upper left corner of the
display (for example: M000).
Note
Note