49
Beyond the Basics
frequency or press d to start searching down from the
highest frequency.
If you press PAUSE while searching, the scanner
stops searching and *** PAUSED *** appears.
Press PAUSE again, and the scanner resumes
searching.
manually tuning a frequency
You can manually set the scanner to move through all
receivable frequencies, or select a specifi c frequency
as a starting point.
1. Press TUNE. The currently-tuned frequency , ***
PAUSED ***, and Fine Tune Mode appear.
2. Use the number keys to enter the frequency where
you want the scanner to start.
3. Press ENT.
4. Press PAUSE. The scanner starts the tune operation.
To change the tune direction, press e or d to tune
up or down. When the scanner fi nds an active
frequency, it stops on the frequency.
5. You can press FUNC TUNE while the scanner is
stopped on a frequency in MANUAL mode to
begin the TUNE function from that frequency. For
example, if the scanner is stopped in MANUAL
mode on channel 144 with frequency 145.31000
MHz, pressing FUNC TUNE will enter TUNE mode
and automatically set the TUNE frequency for
145.31000 MHz.
To Next Page
Loading...
