67
Beyond the Basics
attenuator on or off. ATG or atg appears on the second
line.
Press FUNC and then ATT again to turn off the global
attenuation mode.
Normal ATT. appears on the bottom
line for about 2 seconds.
If you turn on the attenuator, the scanner might not
receive weak signals.
turning the key tone on and off
Each time you press any of the scanner’s keys, the
scanner sounds a tone. To turn the scanner’s key tone
off or on:
1. If the scanner is on, turn OFF/VOL counterclockwise
until it clicks to turn the scanner off.
2. Turn OFF/VOL clockwise to turn the scanner on. Multi-
system Trunking Scanner appears.
3. While Multi-system Trunking Scanner appears, press 1 to
turn on the key tone or 2 to turn it off.
using the dimmer
Repeatedly press DIM to adjust the brightness of the
display backlight to Dark, Light Off, or Light.
changing the display contrast
1. Press MAN.
2. Press FUNC then 9. Use Up/Down keys to set contrast,
ENTER key saves. appears.
To Next Page
Loading...
