you can select either 128, 8, or 1 talk group. For example, you might program every talk group in a police
department by pressing just four keys.
Note: You cannot use partial talk groups in decimal mode. (See “Selecting the EDACS Talk Group ID Format”
on Page XX.)
You can program a specific talk group such as 01-011 into the scan list memory. In AFS mode, you can
program the talk groups for an entire agency by pressing corresponding keys.
For example:
You Press To Scan
01 . E all 01 groups
01 . 01 E all 01 talk groups within
the 01 agency
To enter a Partial EDACS ID:
1. Enter the agency number you want to store. Press ・/CLR /DELAY to enter the dash。
2. Press
E/PGM.
Or you can program all the talk group numbers for one fleet of an agency.
1. Enter the agency number.
2. Press
・/CLR /DELAY to enter the dash.
3. Enter the fleet number.
4. Press E/PGM.
Remember the AFS format allows you to enter full or partial EDACS IDs for powerful flexibility
in all modes. Be sure to read the section. An EDACS Trunked System to learn how this works.
The scanner defaults to “AFS talk group displays for EDACS only.
LTR talk groups
To enter an LTR ID:
For a LTR ID, the area code, home repeater number and
ID make up the talk group ID. See “LTR Tracking for more
information.
1. Enter the area code.
2. Enter the home repeater number.
3. Enter the ID you want to store.
4. Press
E/PGM.
Note: To clear a stored ID while entering an ID, press
0 and E successively, and start over.
Scanning the Talk Group ID Lists
Press
SCAN/MANUAL to begin scanning the lists you have stored.
To Next Page
Loading...
