Radio Shack RPO-137 - Using the Keylock; Turning the Keytone on and off

14
again, select the channel and press Func +
2ABC/DLY. DLY appears.
• To turn on the 2-second delay to search
again, press Func + 2ABC/DLY while the
scanner is searching. DLY appears and the
scanner automatically adds a 2-second delay
to every frequency it stops on in that band.
The Signal Stalker I delay time is 10 seconds.
Using the Keylock
To protect the scanner from accidental program
changes, turn on the keylock feature.
1. To turn on keylock, press Func + KEYLOCK.
Keypad locked appears. When the scanner
is locked, only the knob, Func, and /
/ KEYLOCK are available.
2. To turn off, press Func + KEYLOCK. Keypad
unlocked appears.
Note: Using keylock does not prevent the
scanner from scanning channels.
Turning the Keytone On and Off
Each time you press any of the scanner’s keys, the
scanner sounds a tone. To turn the scanner’s key
tone on or off:
1. Press Menu.
2. Rotate the knob to select 6: Settings, then press
E
PGM
.
3. Rotate the knob to select 2: Key Tone, then
press E
PGM
.
4. Rotate the knob to select 1: On or 2: Off, then
press E
PGM
. Press and hold Menu to exit the
Menu mode.