3. Rotate the knob to select the option you
want, then press E
PGM
.
4. Rotate the knob to select 1: On or 2: Off then
press E
PGM
.
5. Press and hold Menu to exit the Menu mode.
Signal Stalker I Options
1: Only Mode
Set to 1: On to turn on Signal Stalker I and
turn off normal scanning. Set to 2: Off to
continue normal scanning while Signal
Stalker I runs in the background.
2: Voice Interrupt
Set this function to 1: On if you want to
keep the Signal Stalker I active despite
interruptions while the scanner is receiving an
audio signal.
Set this function to 2: Off if you do not want
to hear interruptions. The scanner resumes
checking signals when the audio signal ends.
Voice interrupt note:
While the Signal Stalker I is on and the
scanner is receiving an audio signal (voice)
in normal scanning, the scanner checks the
Signal Stalker I every 2 seconds causing the
audio signal to break at that moment.
3: Logging
Set this function to 1: On to scan log channels
along with normal channels. Set this function
to 2: Off if you do not want to scan log
channels.
Logging notes:
• When the scanner finds a strong signal, it
automatically saves the signal to one of 10 log
channels. If the scanner finds a new frequency
To Next Page
Loading...
