2. Rotate the knob to select the frequency you
want to clear from the skip frequency.
3. Press E
PGM
.
To clear all the skipped frequencies at once while
searching, press SRCH/PSE, then hold down
•CLR / L/OUT until the scanner beeps twice.
Notes:
• If you selected all frequencies to be skipped
within the search range, All channels Locked out! or
All ranges Locked out! appears. The scanner beeps
3 times and does not search.
• If you select more than 200 frequencies to
skip, L/O List Full! appears. Clear any skipped
frequency.
Signal Stalker I
Your scanner’ s Signal Stalker I feature lets you set
the scanner so it detects and then displays the
frequency of a nearby strong radio transmission.
Signal Stalker I works well for locating the source
of strong local transmissions, such as mobile and
handheld two way radios in areas with no other
strong transmission sources.
Signal Stalker I might not correctly display
frequency information for transmitters using a
highly directive antenna (such as an amateur radio
beam antenna), if there are many transmitters
operating at the same time in the same area, or if
the transmitter is a broadcast television station.
Setting the Signal Stalker I Options
1. Press Menu.
2. Rotate the knob to select 4: Signal Stalker,
then press E
PGM
. The Signal Stalker I menu
appears.
To Next Page
Loading...
